Renegade 1/2″ Leveling Kit (Front)

Now that you’ve modified your Jeep with a winch mount or front bumper you will notice the front end now sits lower than the back. Our leveling kit will lift the front end of your renegade to level it out.

• 1/2″ laser cut steel
• Works with Daystar, ATP, AVID, and Teraflex lift kits. Will fit stock vehicles without a lift kit.
• Easy bolt-on installation
• Maintains factory ride quality
• Increased ground clearance
• Levels the front with the rear of the vehicle
• Fits 2015 or newer Jeep Renegade (all models)
• Fits 2nd Gen. Jeep Compass (all models)
• Comes powder coated textured black

IMPORTANT: This spacer kit should only be used to offset or correct drooping in the front and is not intended to be used to add more height onto an existing kit. If your vehicles front end doesn’t sit lower than your back end then this kit may not be right for you. Addition of this kit to a 2″ or more lift without at least a 1/2″ droop in front may cause unnecessary wear on other components. This kit may not be ideal with aftermarket struts and/or springs in combination with a lift kit as it may cause extreme CV axle angles.